Hello everybody,
I have been the owner of a TYT MD 9600 for one week.
Although I have collected some experience in the programming of Codeplugs (with RT3), but for 9600 I have a persistent Problem.
I have successfully created a code plug using the VFO A for 70cm and the VFO B for 2m. But now the following apses:
I chose TG 9 for VFO A, for VFO B I have selected a 2m direct frequency.
I am in a QSO on the VFO B in 2m.
If there is a short break in the QSO and a TG on VFO A is being used somewhere on the Reflector, the loudspeaker symbol jumps from VFO B to VFO A.
Then my partner presses on 2m the PTT again I can not hear him, because the speaker icon is on VFO A.
well noticed
It only moves the speaker icon. I do not hear anything. Unless it is sent on the TG that I have selected on VFO A.
How can I stop this behavior? If I have selected a VFO I do not want an automatic change.
I’ve searched everything, but have found nothing yet. Also on the Internet, I could not find any help or similar Posts.
I would be very happy about this help
vy 73 Thomas, DO3GE