|
|
#1
12-15-2017, 05:08 PM
|
|||
|
|||
TYT MD-9600 VFO Mode
I have successfully programmed the radio and use it in both the digital and analog modes, but when I go to VFO mode I am unable to transmit. The radio indicates it is in the VFO mode, I am able to set whatever frequency I would like within the 2m or 70cm bands but when I attempt to transmit the radio emits a load beep. I cannot find any settings in the CPS software that is allowing or disallowing VFO transmission or any settings within the Radio Menu itself. Does anyone have any experience with this.
|
|
#2
02-22-2018, 02:29 AM
|
|||
|
|||
Re: TYT MD-9600 VFO Mode
Still experiencing the same concern until now?
|
 |
| Bookmarks |
| Tags |
| programming, vfo |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
