Two Way Radio Forum  

Go Back   Two Way Radio Forum > Two Way Radios > Business Radios

Click here to visit our ecommerce site - BuyTwoWayRadios.com

Reply
 
Thread Tools Display Modes
  #1  
Old 05-21-2018, 10:14 PM
Tator_Soldier Tator_Soldier is offline
Junior Member
 
Join Date: May 2018
Posts: 1
Default Hytera Two way Radio help!

First post on this forum, hopefully I can get some answers as I'm new to the electronics repair scene. I have 5 Hytera TC-600 two way radios. All of them have been reprogrammed (to the best of my ability) to have the same settings and channels. Squelch is set to 2, with power output on high. Two of the radios will receive signal when on squelch setting 2, the other 3 will transmit but will not receive unless the squelch is opened ALL the way, even then it's a quiet signal. Why would this be? is there a setting that I can mess with to try and remedy this (side note, I noticed a tuning option in the programming software, but I'm not knowledgeable enough to trial and error with those settings) or if there's some type of testing I can do on the electronics to check functionality. Just need somewhere to start. I recently acquired an oscilloscope with 50mhz capabilities, AN/USM-281 to be exact.

Any and all help would be appreciated!!!
I did post this on a electronics forum, as Im not sure how much of a response I'll get either here or there.
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:50 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Copyright 2018, Cricket Ventures LLC